1/10 2WD Stadium Truck Lower Lexan Body for XT2 Series - XRAY 329722  [XR-329722]

Price:
£38.69
Brand:
XRAY
Model:
XR-329722
Condition:
Brand New
Write a review

Designed Lower Shell for XT2 Series

The XRAY 329722 lower body is an RC-scale, low-profile Lexan shell engineered to fit the XT2 series stadium truck layout. The panel geometry was adjusted to match shorter shock lengths and a lower shock tower position, allowing the body to sit closer to the chassis.

Mounting points were revised and trimming lines refined to provide a precise fit with XT2 layouts; prepare for a careful test-fit and follow the printed trim guides to avoid excess cutting. The body’s profile reduces aerodynamic lift and helps concentrate mass lower on the model, supporting predictable handling during cornering and landing transitions.

When tuning, expect the lower body position to complement suspension settings aimed at roll control and chassis balance rather than increasing mechanical grip alone. Check clearance around the suspension and steering linkages after final mounting, and confirm no contact with the motor or electronics in 2WD configurations.

Specifications

  • Item: Body 1/10 2WD Stadium Truck - Lower
  • Material: Lexan
  • Model Number: 329722
  • Compatibility: XT2 Series, XT2 2028

This lower Lexan body is intended to integrate with XT2-series setups where a reduced ride height and refined aerodynamics are desired; confirm fit with your shock and tower configuration before final installation.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can this body be used on non-XT2 chassis?

It is designed for XT2-series geometry. You may fit it to other platforms only after confirming shock tower height and mounting post positions match the printed trim and hole pattern.

Does the shell require reinforcement after trimming?

Usually no extra reinforcement is needed if you stick to the trim lines. Inspect cut edges and consider light edge tape for high-wear areas if you race aggressively.

What should I watch for during a test fit?

Ensure full suspension travel is unobstructed, steering clearance is maintained, and there is no contact with the motor or electronics before securing the body.

Will the lower profile require setup changes?

Expect the chassis to behave with a slightly lower center of gravity; minor suspension tweaks focusing on roll control and balance will help retain predictable handling.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved