XRAY 333460 Composite Rear Anti-roll Bar Ball Joint Set  [XR-333460]

XRAY #333460 Composite Anti-roll Bar Ball Joint 5.8 mm (4)
Price:
£6.77
Brand:
XRAY
Model:
XR-333460
Condition:
Brand New
Write a review

Improve rear roll control with XRAY 333460 composite joints

Model racers seeking steadier rear-end balance can fit the XRAY 333460 Composite Anti-roll Bar Ball Joint Set. These 5.8mm ball joints are produced in molded composite to give a precise interface with rear anti-roll bar linkages and resist routine wear.

Key points about the XRAY 333460 set

  • Material: Molded composite for reliable strength and consistent behaviour under load.
  • Size: 5.8mm dimension to match rear anti-roll bar link systems.
  • Quantity: Four items included to replace both sides or keep as spares.
  • Compatibility: Designed to suit a variety of RC chassis that require 5.8mm rear ball joints.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will these reduce play in the rear linkage?

If worn joints are the cause of play, replacing them with these composite units will tighten up the linkage and improve consistency.

Do composite joints need special care?

Basic checks for dirt and damage are enough; clean gently and replace if the joint shows signs of excessive wear.

Is fitment straightforward for a home mechanic?

Yes, installation is standard for rear anti-roll bar links that accept 5.8mm ball joints. Use correct tools and verify alignment after fitting.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved