XRAY 371172 X10 Carbon Rear Pod Lower Plate Precision Edition  [XR-371172]

Price:
£16.65
Brand:
XRAY
Model:
XR-371172
Condition:
Brand New
Write a review

Improve X10 Rear Stability with a Carbon Lower Plate

Club and competitive drivers looking for tighter rear control can use the XRAY 371172 Carbon Rear Pod Lower Plate. Intended for the 1-piece chassis, this carbon plate increases structural stiffness and helps produce steadier handling under load.

Precision Carbon Fabrication

The XRAY 371172 is produced from premium carbon fibre to deliver a focused increase in rigidity while keeping the mass low. That combination helps the X10 remain responsive and reduces unpredictable flex in fast transitions. The accurate manufacturing ensures consistent fit and performance.

Compatibility and Simple Installation

Specifically matched to the XRAY X10 1-piece chassis, the plate installs with the stock mounting layout and requires minimal adjustment. Fit it quickly and evaluate handling changes trackside. The added rear pod stiffness contributes to more controllable handling in demanding race conditions.

Core Advantages

  • Material: Robust carbon fibre offering longevity and low weight.
  • Design: Precisely shaped for the XRAY X10 1-piece chassis for correct alignment.
  • Performance: Improves consistency and stability for competitive driving.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this compatible with X10 variants that use hop-up parts?

It is compatible when the hop-up maintains the original 1-piece rear pod mounting. Some third-party modifications may require verification before fitting.

How should I check fastener torque on carbon parts?

Use measured torque and avoid over-tightening. Hand-tighten then apply small increments with a torque driver or use a firm fingertip finish to prevent crushing the carbon at screw bosses.

Does the plate affect centre of gravity significantly?

The plate is light and designed to add stiffness rather than mass, so any change to centre of gravity is minimal while handling gains are more noticeable.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved