3RACING 3RAC-HKS30/RE 3.0mm Red Aluminium Servo Arm for Ko Propo and Sanwa  [3RAC-HKS30/RE]

3RACING 3.0mm Aluminium Single Servo Arm For Ko Propo/Sanwa - Red - 3RAC-HKS30/RE
Price:
£2.63
Brand:
3Racing
Model:
3RAC-HKS30/RE
Condition:
Brand New
Write a review

Precision Upgrade with the 3RACING 3RAC-HKS30/RE Servo Arm

The 3RACING 3RAC-HKS30/RE 3.0mm aluminium single servo arm is a purposeful upgrade for modders seeking steadier steering response. Its red anodised finish gives corrosion resistance and easy visual identification when working on your model.

Stability and Reduced Deflection

Aluminium construction at 3.0mm thickness provides a stable platform that limits deflection under steering loads. That stability helps keep steering predictable across repeated laps and rough sections.

Compatibility Notes and Installation Tips

Built for Ko Propo and Sanwa horn patterns typically found in 1/10 scale cars, this arm is a direct swap in many setups. Use matching mounting screws and check alignment after installation to prevent binding.

Does this arm require extra weighting to balance the car?

No additional weight is normally required. The arm is lightweight by design, but check overall balance after fitting if you are tuning handling characteristics.

Can I use this on both front and rear steering setups?

It can be used wherever the servo spline and screw layout match. Confirm the application and steering geometry to ensure correct operation.

How often should I inspect the servo arm?

Check the arm after any impact and during routine maintenance. Tighten mounting screws and replace the arm if you see deforming or excessive wear.

Is the red anodise purely cosmetic?

The red anodise provides corrosion resistance and surface hardness as well as aesthetic appeal, so it serves both functional and visual purposes.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved