3RACING 64 Pitch 57T Pinion Gear with Hard Coating (7075) - 3RAC-PG6457 Race Edition  [3RAC-PG6457]

3RACING 64 Pitch Pinion Gear 57T (7075 w/ Hard Coating) - 3RAC-PG6457
Price:
£3.29
Brand:
3Racing
Model:
3RAC-PG6457
Condition:
Brand New
Write a review

Optimise gear engagement with a 57 tooth aluminium pinion

The 3RACING 64 Pitch Pinion Gear 57T provides a tidy upgrade for on-road kit owners wanting consistent mesh. Made from 7075 aluminium and finished with a hard coating, it helps reduce abrasive wear and maintains gear geometry.

Why this pinion is practical

Focused on dependable service rather than flash, this pinion uses strong 7075 aluminium and a wear-resistant surface to keep performance steady session after session. It is a sensible part for club and local racing.

Compatibility notes

The 64 pitch, 57 tooth configuration matches many 1/10 on-road gear setups and gives a balanced ratio for acceleration and top speed on smooth surfaces. Always check bore size and set-screw arrangement before fitting.

Will this pinion fit standard 64 pitch spurs?

Yes, it is made for 64 pitch systems. Confirm the spur uses the same pitch and that the motor shaft and set-screw alignment match the pinion.

Can I reuse my existing motor pinion grub screws?

You can usually reuse grub screws if they are in good condition and fit the pinion holes properly. Replace any worn screws to avoid slippage.

Is there an advantage over steel pinions?

Aluminium pinions are lighter and can be sufficient for many racing environments, while steel pinions resist heavy wear from extreme power. Choose based on power levels and wear expectations.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved