3RACING 3RAC-WF305/BU Blue M3 0.5mm Flat Washers 10 Pack  [3RAC-WF305/BU]

3RACING Aluminium M3 Flat Washer 0.5mm (10 Pcs) - Blue - 3RAC-WF305/BU
Price:
£2.10
Brand:
3Racing
Model:
3RAC-WF305/BU
Condition:
Brand New
Write a review

Accurate spacing with 3RACING aluminium shims

The 3RACING Aluminium M3 Flat Washer set contains ten flat washers at 0.5mm thickness, giving you fine increments for setup changes. These slim aluminium shims are useful when a few tenths of a millimetre make a handling difference.

Typical applications in model cars

Use the washers to adjust suspension geometry, set motor height, or fine tune link positions. The lightweight aluminium construction helps keep component weight low while offering routine corrosion resistance for everyday running.

Compatibility summary

Manufactured to fit standard M3 hardware and suitable for many 1/10 scale touring and drifting cars, this washer set supplies repeatable spacing in common RC assemblies without adding unnecessary bulk.

How many washers should I use for suspension shims?

Start with a single 0.5mm washer and test; add increments as needed until the desired ride height or alignment is achieved, then secure and recheck clearances.

Will these washers work with wheel hexes and hubs?

They fit M3 fastenings commonly found on hubs and mounting points, but verify screw type and seating area to ensure a proper fit in your specific hub design.

Any tips for installing these thin washers?

Handle them with tweezers for neat placement, and avoid overtightening screws which can flatten the washer and change the intended spacing.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved