3RACING SAK-C147E Cero Drive Shaft Bush Service Upgrade  [SAK-C147E]

3RACING Cero Drive Shaft Bush - SAK-C147E
Price:
£2.84
Brand:
3Racing
Model:
SAK-C147E
Condition:
Brand New
Write a review

Service Bush for 3RACING Cero SAK-C147E Drive Shaft

The 3RACING SAK-C147E drive shaft bush is a dedicated replacement component that helps lower friction in the Cero driveline. Properly installed, it restores smooth rotation and helps maintain predictable drivetrain behaviour on layout and race day.

Why It Matters

The bush reduces direct contact between moving parts, cutting down wear on shafts and couplings and helping preserve gear alignments. It is made to fit Cero series parts for consistent performance.

Installation and Care

Seat the bush squarely in its bore and inspect the shaft for scoring or uneven wear before reassembly. Clean contact areas and recheck during routine service intervals to get the most from the replacement part.

Is the SAK-C147E sold individually?

Check the vendor listing for quantities, but this part is typically offered as a single replacement component for the Cero series.

Any run in needed after fitting?

A short break in at low loads can help the bush seat in and smooth initial contact; verify smooth rotation before returning to full pace.

Can I upgrade to bearings instead?

Some setups allow bearing conversions, but check chassis space and shaft sizing first. The bush is a compact, low maintenance option where bearings are not fitted.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved