3RACING Cero M3 x 8 x 1.5 Lower Suspension Spacer SAK-C167A Performance Shim  [SAK-C167A]

3RACING Cero M3 x 8 x 1.5 Lower Suspension Spacer - SAK-C167A
Price:
£2.88
Brand:
3Racing
Model:
SAK-C167A
Condition:
Brand New
Write a review

Refine Handling with a 3RACING Suspension Shim

The 3RACING SAK-C167A M3 x 8 x 1.5 Lower Suspension Spacer gives a straightforward method to alter suspension geometry on Cero cars. It is a compact tuning option for drivers seeking measured changes to balance and stability.

Application for Road and Track

These spacers are used to tweak the lower mounting stack so you can fine tune roll behaviour and steering bite. They are suitable for both track sessions and spirited club running where small changes make a difference.

Quick Fit and Setup Workflow

The M3 x 8 x 1.5 specification matches common lower fastener stacks, allowing rapid trials of different spacer counts. Fit one, run a few laps, and compare to your baseline to determine the best setup.

Can I use this spacer for both front and rear?

Yes, if your front and rear lower mounts use the same M3 stack dimensions you can apply the spacer to either location, but expect different handling changes depending on axle placement.

How many shims should I try first?

Start with a single spacer and test. If more change is needed, add another and test again, recording lap times or driver feedback for each step.

Will this spacer affect ride height?

It can slightly alter static geometry but is primarily a geometry tuning tool rather than a ride height mod. Always recheck ride height and alignment after changes.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved