3RACING Crawler Ex Real 60T Spur Gear CRA-116 Maintenance Gear  [CRA-116]

3RACING Crawler Ex Real 60T Spur Gear - CRA-116
Price:
£3.75
Brand:
3Racing
Model:
CRA-116
Condition:
Brand New
Write a review

Essential notes for crawler drivetrains

The 3RACING Crawler Ex Real 60T Spur Gear CRA-116 is supplied as a practical service or upgrade part for RC crawlers. It supports smooth power flow through the transmission, helping maintain traction and control in technical sections.

Key fitment and use points

The 60 tooth configuration is chosen to provide a measured balance between torque and rotational response for slow speed crawling. The gear works well for enthusiasts who keep an eye on drivetrain condition and prefer predictable engagement under load.

Maintenance and setup advice

Installing the spur typically involves swapping the existing gear and checking pinion mesh. Correct alignment and routine inspection will extend gear life and preserve drivetrain efficiency so you can focus on refining your driving lines.

Is this spur a direct replacement for stock gears?

Often it will replace stock spurs, but confirm measurements like bore and tooth count against your current gear to ensure a direct swap.

Will changing spur gear affect motor load?

Gearing affects motor load; a larger spur or different pinion will change torque requirements. Choose gearing to match motor and ESC limits to avoid overheating.

What should I check after fitting the new spur?

After fitting, verify pinion mesh, rotate the drivetrain by hand to detect binding, and run a short test at low speed to confirm smooth engagement before full use.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved