3RACING CRA-110 34T Bearing Gear for Crawler Ex Real  [CRA-110]

3RACING Crawler Ex Real 2 Speed Bearing Gear 34T - CRA-110
Price:
£2.85
Brand:
3Racing
Model:
CRA-110
Condition:
Brand New
Write a review

Optimise Low Speed Control with the 3RACING CRA-110

The 3RACING Crawler Ex Real 2 Speed Bearing Gear 34T, model CRA-110, is a straightforward upgrade aimed at improving low speed drivetrain stability for Crawler Ex Real vehicles. It supports predictable torque transfer for precise manoeuvring on technical lines.

Designed for Regular Crawling Use

This 34T gear delivers consistent meshing under load and is suitable for enthusiasts who run frequent trail sessions. It is intended to reduce drivetrain fuss and keep your crawler ready for extended outings.

Fitment and Quick Swap Guide

The CRA-110 matches the Crawler Ex Real series fitment, making replacement or upgrade straightforward. A careful check of gear mesh and bearing condition during installation will ensure best performance.

Is this a direct replacement for the stock Crawler Ex Real gear?

Yes, the CRA-110 is designed to replace the original 34T gear in the Crawler Ex Real lineup without requiring chassis modifications.

Should I check bearing wear when fitting the new gear?

Inspect bearings and replace if they show play or roughness. Fresh bearings help the new gear run smoothly and extend service life.

Will this gear reduce drivetrain noise?

Properly installed and meshed, the CRA-110 can reduce irregular noise by providing steady engagement, though noise also depends on pinion and bearing condition.

Any setup tips after installation?

After fitting, check gear mesh, run the drivetrain by hand and do a short low speed test. Recheck fasteners and bearing seating after an initial run.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved