3RACING 3RB-MR83-ZZ/2 Double Metal Shield Bearings 3x8x3mm (2pcs)  [3RB-MR83-ZZ/2]

3RACING Double Metal Shield Bearing 3 x 8 x 3 mm (2 pcs) - 3RB-MR83-ZZ/2
Price:
£1.13
Brand:
3Racing
Model:
3RB-MR83-ZZ/2
Condition:
Brand New
Write a review

Shielded Bearings for Longer Component Life

The 3RACING Double Metal Shield Bearing 3 x 8 x 3 mm helps sustain smooth operation across wheels and driveline parts. These bearings aim to cut friction and slow wear to keep running consistent over multiple sessions.

Protection and Performance

Metal shields guard the bearing interior from dust and small debris, while the double shield layout enhances that protection. This reduces the chance of grit-induced damage and helps maintain bearing integrity.

Recommended Uses

Compatible with any RC component accepting 3 x 8 x 3 mm bearings, these are suitable for club racing, practise, and general bashing. They are useful where reduced rolling resistance and fewer maintenance visits are priorities.

Will these bearings fit hobby kits that use 3x8x3 bearings?

Yes, any kit specifying 3 x 8 x 3 mm bearings can accept these as a shielded option to reduce contamination and extend service intervals.

How should I clean shielded bearings?

Remove and wipe them with a clean cloth and use a light solvent or bearing cleaner if contaminated, then re-lubricate lightly before refitting.

Are these good for wet conditions?

They offer better dust protection than open bearings but are not fully waterproof. For wet or muddy runs choose fully sealed bearings and perform maintenance after each wet session.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved