3RACING Titanium Droop Gauge -4 to 10mm ST-004/TI - Race Ready Gauge  [ST-004/TI]

3RACING Droop Gauge -4 to 10mm - Titanium - ST-004/TI
Price:
£5.70
Brand:
3Racing
Model:
ST-004/TI
Condition:
Brand New
Write a review

Precision droop checks with the 3RACING ST-004/TI

The 3RACING Titanium Droop Gauge -4 to 10mm ST-004/TI delivers accurate droop measurement for suspension setup. With a -4 to 10mm range, it helps racers and club drivers set repeatable ride heights to suit different circuits and conditions.

How it fits into your setup routine

Use the gauge when balancing front and rear droop or when testing new shock rates. Consistent droop measurements cut down on trial-and-error and let you compare changes more reliably between runs.

Reliable titanium construction

Constructed from titanium, the gauge resists wear and remains lightweight for easy handling during pit work. Its sturdy nature means it will keep providing accurate readings session after session.

Will this gauge work for touring and buggy classes?

It is primarily aimed at 1/10 scale touring cars but is equally useful for buggies if your droop requirements fall within the -4 to 10mm range.

Where should I place the gauge on the chassis?

Place it at your chosen droop reference point on the chassis while the car is on its wheels. Compare left and right readings to confirm symmetry and make small adjustments as needed.

Can I carry this in a pit bag without marking it?

Yes, titanium resists corrosion and most marks wipe off easily, so it travels well with other tools in a pit bag and stays accurate for regular checks.

Do I need special tools to use it?

No other tools are required to take a droop reading, though a flat surface and basic notebook or phone notes will help you track settings across test runs.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved