TAMIYA GB-01 Series 2 Degree Aluminium Rear Hub GB-04/2/LB by 3Racing  [GB-04/2/LB]

2 degree aluminium rear hub for GB-01 family

The GB-04/2/LB is a light blue anodised aluminium rear hub intended for TAMIYA GB-01, GB-01T and GT-01 chassis as a 2 degree option. It is made to follow the stock hub footprint while changing the rear wheel angle by the stated 2 degree offset.

This hub provides a metal alternative to plastic rear hubs for more repeatable behaviour under load. The small 2 degree offset is useful when fine-tuning rear tracking and cornering balance during setup and testing.

Fitting is the same basic routine as the original part: remove the wheel and wheel nut, detach the stock hub from the rear upright, swap the new hub in place and reassemble using the existing fasteners and wheel hardware. Standard hobby hex drivers are usually all that is required, subject to GB-01/GB-01T/GT-01 upright and axle compatibility.

Sold for RC model chassis tuning use only; check fitment on your specific vehicle before demanding use.