M03M Rear Hub Carrier 1 Degree Aluminium, Light Blue - M03M-12/1/LB by 3Racing  [M03M-12/1/LB]

Aluminium rear hub carrier for fine tuning

This aluminium rear hub carrier is intended for Tamiya M03M mounting arrangements and carries the part number M03M-12/1/LB. The unit is finished in light blue and includes a 1 degree offset to enable modest rear alignment changes without replacing major suspension parts.

Fitment is specific to M03M-style rear knuckles and wheel hex interfaces. Before fitting, verify the carrier bolt pattern and hex clearance correspond to your original rear knuckle to avoid mismatch.

Installation is straightforward: remove the rear knuckle assembly, replace the OEM carrier with this aluminium piece, then reassemble while checking wheel alignment and suspension travel. Because the offset is small, evaluate handling after the swap and make minor toe or link adjustments if required.

As a hop-up accessory, this carrier is aimed at setup and tuning tasks rather than as a singular performance upgrade; the material and finish are the main differences to note.