3Racing 4.8mm Ball End Kit for Sakura D3 CS SPORT 3RAC-BE4816/V2 16mm & 12mm  [3RAC-BE4816/V2]

3RACING Sakura D3 CS SPORT 4.8mm Ball End Set - 16mm & 12mm /V2 - 3RAC-BE4816/V2
Price:
£1.89
Brand:
3Racing
Model:
3RAC-BE4816/V2
Condition:
Brand New
Write a review

4.8mm Ball End Upgrade for Sakura D3 CS SPORT

The 3Racing 4.8mm ball end set comes with 16mm and 12mm lengths to fine-tune suspension geometry on the Sakura D3 CS SPORT. They provide a consistent pivot point that helps maintain predictable handling during drift runs.

Sturdy Construction for Consistent Use

Built to resist routine wear, the 3Racing ball ends aim to keep play to a minimum and preserve steering precision over time. That consistency helps keep setup repeatable session to session.

Exact Fitment for Correct Handling Response

Specifically made to suit the Sakura D3 CS SPORT linkage layout, this set fits without compromise so suspension travel and steering remain true. Use the different sizes to tweak front to rear balance.

Do these require thread locking?

Apply a small amount of thread locker on metal-to-metal joints if you experience loosening, but avoid heavy adhesives that make future adjustments difficult.

How do I check for wear in the ball joint?

Look for side-to-side slop or a rough feel when the joint moves. Any noticeable play indicates the ball cup or the ball end itself should be replaced to retain precise handling.

Can these be used with carbon fibre steering plates?

They can be used with compatible carbon fibre plates provided the mounting hole and ball cup spacing match. Check clearances and thread compatibility before installing.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved