Sakura D4 King Pin 5.8mm Ball Stud SAK-D422 3Racing  [SAK-D422]

3RACING Sakura D4 King Pin 5.8mm Ball Stud For D4 - SAK-D422
Price:
£3.73
Brand:
3Racing
Model:
SAK-D422
Condition:
Brand New
Write a review

Refine steering on the Sakura D4

The 3Racing Sakura D4 King Pin 5.8mm Ball Stud SAK-D422 is an effective replacement for worn stock studs, delivering steadier front end behaviour. It is aimed at drivers who want consistent steering through practice and events.

Consistent response under race conditions

Manufactured to reduce play in the steering linkage, the 5.8mm ball stud from 3Racing keeps inputs clean and repeatable. That consistency helps drivers trust the car when pushing for lap time improvements.

Maintain control with a simple swap

Fitting the 3Racing SAK-D422 gives better longevity and steadier handling without major setup changes. It is a practical upgrade for anyone maintaining or refreshing a Sakura D4 for club or regional competition.

Can I reuse old hardware when fitting this?

You can reuse compatible nuts and washers if they are in good condition, but replace any worn fixings to ensure secure installation and correct clamping force.

Is this suited to wet conditions?

The part is robust but after wet runs inspect and dry the steering assembly. Light corrosion protection and routine checks will keep function reliable in damp environments.

Where should I check for play after fitting?

Check the king pin joint and tie rod ends for axial or radial movement. Any noticeable free play should be addressed before high speed running.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved