3Racing GRAP-1020 2.0mm Woven Graphite Plate - RC Fabrication Panel  [GRAP-1020]

3RACING 2.0mm Woven Graphite Plate (2.0 x 200 x 450mm) - GRAP-1020
Price:
£36.31
Brand:
3Racing
Model:
GRAP-1020
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Stiff Woven Graphite Panel for RC Fabrication

Model makers and racers who need a consistent, low weight material will appreciate the 3Racing GRAP-1020 2.0mm woven graphite plate. The plate measures 2.0 x 200 x 450mm and is practical for cutting custom parts or strengthening sections of a chassis.

How Woven Graphite Affects Chassis Behaviour

Because woven graphite distributes load across the weave, it raises stiffness while keeping mass down. That makes it a good choice for bracing key areas and improving predictability at speed.

Adaptable for Repairs and Custom Work

The GRAP-1020 sheet is straightforward to trim and mount for repairs or one-off parts. It bonds well with common adhesives and accepts machine screws when used with proper reinforcement plates or washers.

Will the GRAP-1020 change my car balance significantly?

Adding graphite in low positions tends to lower weight transfer and can reduce understeer, but results depend on where the plates are fitted and the vehicle setup.

Are there special storage or handling needs?

Store flat to avoid warping and handle edges carefully to prevent fibre splinters; wear a dust mask when sanding or cutting.

Can I use the plate for both front and rear reinforcement?

Yes, the plate can be cut to size for front or rear bracing; consider layout and mounting points to achieve the desired stiffness distribution.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved