3Racing SAK-D6821F Dual Joint Pin 1.5x7.8 for Sakura D6 [SAK-D6821F]

3RACING KIT-SAKURA D6 Dual Joint Pin M1.5 x 7.8 - SAK-D6821F

Price:

£0.97

Brand:

3Racing

Model:

SAK-D6821F

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Durable Dual Pins for Sakura D6

The 3Racing SAK-D6821F Dual Joint Pin is produced to marry with the Sakura D6 chassis, providing a dependable joint interface and extended service life. At M1.5 x 7.8mm, these pins help preserve steering precision and resist deformation under load. They are useful spares for competitors and hobbyists who expect consistent front-end response.

Are special clips needed to retain the pins?

Retention depends on your linkage layout. Some setups use clips or e-clips, while others rely on the joint geometry. Verify your current fixings before fitting.

Can I polish these to reduce friction?

Light deburring or smoothing is acceptable, but avoid removing material that would change diameter or seating. Maintain the M1.5 x 7.8mm spec for correct fit.

What signs indicate replacement is needed?

Look for increased play, visible wear marks, or bent pins after impacts. Replace pins showing any of these faults to prevent steering issues.