3RACING RC18T/RC18R Rear Toe-Out Mount 0 Degree Aluminium RC18-016/SI  [RC18-016/SI]

Fixed rear toe-out mount for RC18 platforms

This aluminium rear toe-out mount is an aftermarket replacement compatible with Team Associated RC18T and RC18R chassis, supplying a fixed 0 degree toe reference for the rear hub. It is aimed at 1/18 scale racers who need repeatable setup points.

The mount uses the RC18T/RC18R rear hub bolt pattern and gives a more rigid mounting surface than plastic alternatives, helping to reduce geometry changes under cornering loads and keeping toe consistent.

Installation is direct to the original rear hub locations using factory hardware. Tighten bolts to a sensible torque to avoid thread damage and check alignment after the first runs since the mount is a fixed geometry component, not an adjustable link.

Fit this mount when validating baseline suspension geometry or when a repeatable 0 degree rear toe-out is needed for comparison runs; inspect the mount for any nicks or loosening after sessions to maintain predictable handling.