3RACING Sakura XI Zero Low Friction Front Belt 516 (Bando) SAK-X08 Low Drag Upgrade  [SAK-X08]

3RACING Sakura XI Sakura Zero Low Friction Front Belt 516 ( Bando) - SAK-X08
Price:
£4.26
Brand:
3Racing
Model:
SAK-X08
Condition:
Brand New
Write a review

Refining Sakura XI front drive with a low friction belt

RC pilots seeking a tidier front end will find the 3Racing low friction front belt a useful upgrade for Sakura XI builds. It reduces rotating resistance so steering feedback feels more precise under braking and corner entry.

Why the belt improves control

By lowering friction losses in the belt run, more power is available at the wheels which improves throttle response and consistency lap after lap. That makes car setup more predictable during competitive runs.

Installation and upkeep advice

Fit the belt on a clean chassis and confirm pulleys are concentric. Monitor belt condition after high mileage sessions and replace when wear or stretch becomes evident to maintain consistent performance.

Does the belt need a break in period?

A short break in with gentle runs helps the belt seat properly. After the initial session, recheck tension and pulley alignment to ensure even wear.

Can I run this belt on wet tracks?

Occasional wet running is fine but prolonged exposure to water and grit can accelerate wear. Dry and clean the drive area after wet use to prolong belt life.

Is there any special maintenance after racing weekends?

Inspect for debris, clean pulleys, and confirm the belt has not stretched or nicked. Regular checks keep performance consistent and reduce the risk of mid event failures.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved