3Racing Tamiya TT-02 Shock Tower Mount Replacement TT02-05 - Replacement Part  [TT02-05]

Tamiya TT-02 Shock Tower Mount - 3Racing TT02-05
Price:
£11.24
Brand:
3Racing
Model:
TT02-05
GTIN:
4895124755150
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Shock tower mount for TT-02 maintenance

The TT02-05 serves as a direct spare for Tamiya TT-02 cars. It secures the shock tower and is an important component when setting up suspension geometry for predictable handling.

Compatibility and fitment: matches common TT-02 tower mounting positions. Verify the tower hole pattern and screw length on your chassis before installing to maintain alignment and correct ride height.

Installation notes: use original or equivalent mounting hardware and ensure the tower is seated flush and shocks articulate freely. Replace any compromised screws to avoid loose mounting under load.

Tuning role: the mount sets shock attachment points and affects camber link geometry and leverage. When changing tower positions, confirm that the selected holes preserve the travel and leverage needed for your tuning objectives.

Specifications

  • Item: Shock Tower Mount
  • Material: Not specified by manufacturer
  • Model Number: TT02-05
  • Compatibility: Tamiya TT-02 chassis

Ideal as a straight replacement or part of stepwise suspension changes on TT-02 models; always confirm hardware and shock geometry after fitting.

Is this suitable for race or club kits?

It is compatible with standard TT-02 layouts found in many kits; race setups may require careful verification of hole positions to match tuning plans.

What should I look for after fitting?

Confirm the tower is flat against the mount, cycle the suspension to check for binding, and recheck fastener torque after a short test run.

Does the material affect tuning?

Material can influence stiffness of the mounting point, but since the manufacturer has not specified material, treat it as a direct replacement and tune geometry as needed.

Can I swap towers between models?

You can swap towers if the hole patterns match; always verify shock angles and link geometry after swapping to ensure handling remains consistent.

Recommended maintenance interval?

Inspect tower mount hardware after several sessions or after hard impacts; tighten fasteners and replace any deformed parts to keep suspension predictable.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved