Tamiya 54847 Carbon Rear Damper Stay - TB05 Race Accessory  [54847]

Tamiya 54847 - TB05 Carbon Rear Damper Stay (for TRF SS Big Bore Dampers) OP-1847
Price:
£12.17
Brand:
Tamiya
Model:
54847
GTIN:
4950344548477
Condition:
Brand New
Write a review

Carbon Rear Damper Stay for Tuned TB05 Chassis

The Tamiya 54847 Carbon Rear Damper Stay is a useful upgrade for TB05 cars seeking improved balance. Engineered for TRF Super Short Big Bore Dampers, it helps lower the centre of gravity and stabilise corner exits.

3mm Carbon for Strength and Low Weight

Constructed from 3mm carbon fibre, this stay provides high stiffness while keeping mass down. The six mounting holes allow a variety of rear damper positions so you can tune response to match grip levels.

Designed for TB-05 PRO Installation

This rear damper stay is intended for the TB-05 PRO chassis when used with TRF Super Short Big Bore Dampers and is designed for straightforward installation to trial different setups.

Will this part help improve lap consistency?

By stiffening the rear and lowering the centre of gravity, the stay can improve handling consistency, which often leads to more repeatable lap times when paired with suitable damping.

Are special shock tops required?

There are no mandatory shock top changes, but ensure your shock lengths and mounting arrangements are compatible with the stay before final assembly.

How should I look after the carbon stay?

Clean it after runs, inspect for chips or delamination, and replace the part if any structural damage is found to maintain safe handling.

Any setup tips for different surfaces?

Use stiffer mounting positions on high grip venues and more relaxed positions on low grip tracks to fine tune rear traction and rotation.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved