6mm Gold Mass Damper Ball M4WD-04/GO for Mini 4WD by 3Racing  [M4WD-04/GO]

M4WD-04/GO 6mm gold ball for Mini 4WD mass-damper setups

This 6mm gold damper ball is produced as an aftermarket mass-damper element for Mini 4WD systems. It is sized to fit common 6mm damper housings and provides a compact weighted contact point intended to influence the inertial behaviour of small damper assemblies.

Suitability depends on the carrier design and available clearance on the chassis and bodywork. Builders should check internal bore diameter and retaining hardware compatibility prior to fitting. The item is supplied as a single weighted ball and follows conventional damper assembly methods.

Usual care for small metal components applies: keep contact areas clean, confirm retained clearance after fitting, and inspect the gold finish for wear from repeated contact. This note addresses appearance and serviceability rather than claiming functional performance changes.