Tamiya 9335777 Precision Idler for 1/18 Konghead 6x6 G6-01 Drive Train  [9335777]

Tamiya 9335777 - Idler Gear: 58646 1/18 Konghead 6x6 G6-01 - 19335777
Price:
£10.65
Brand:
Tamiya
Model:
9335777
GTIN:
1852888854584
Condition:
Brand New
Available in warehouse
Write a review
alt="Tamiya 9335777 - Idler Gear: 58646 1/18 Konghead 6x6 G6-01 - 19335777" title="Tamiya 9335777 - Idler Gear: 58646 1/18 Konghead 6x6 G6-01 - 19335777"

Precision idler gear for stable drive performance

The Tamiya 9335777 idler gear is an essential component in the 1/18 Konghead 6x6 G6-01 transmission. It helps distribute power through the gearbox and smooths the overall drive feel.

Designed fit and performance

Specifically produced for the Konghead 6x6 G6-01, this idler provides accurate tooth geometry for consistent engagement with mating gears. Proper fit reduces vibration and extends the service life of related parts.

Practical fitting guidance

When installing the Tamiya 9335777 idler gear make sure mating surfaces are clean and free of debris. Check shaft end float and gear mesh, then run a short trial to confirm even contact and silence in the gearbox.

Will this idler fit other gearboxes on similar scale models?

It is intended for the Konghead 6x6 G6-01. Other models with matching shaft diameter and gear spacing might accept it, but verify dimensions before installation.

What routine checks should I carry out?

Regularly inspect for play, uneven teeth wear and bearing smoothness. Clean the gearbox periodically and replace the idler if any damage is evident to avoid secondary failures.

Any tips for quieting gearbox noise?

Correct gear mesh and secure mounts are the main factors. Use a small amount of appropriate grease on bearings and ensure the idler is free-running without side load to reduce noise.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved