Aftermarket BB DJC Wheel Axle by Arrowmax AM-010083 - Spring Steel  [AM-010083]

Arrowmax AM-010083 BB DJC Wheel Axle (Spring Steel)
Price:
£9.65
Brand:
Arrowmax
Model:
AM-010083
Condition:
Brand New
Write a review

Short product summary

The Arrowmax AM-010083 BB DJC Wheel Axle is a spring steel RC-scale replacement engineered for compact hub fitment and consistent service during routine practice or track days. It is intended for model use and does not represent a real vehicle component.

As a structural element the axle carries wheel mounting loads into the hub and bearing stack and is frequently used while adjusting wheel offset, alignment and runout. The spring steel construction supplies elastic recovery and good wear resistance for repeated disassembly and reassembly typical of maintenance cycles.

Fitment notes: check the axle interface against your hub bore and bearing stack before installation, inspect 走珠軸承 and hub bores for wear, slide the axle through the hub and bearings, secure with your original hub fasteners and confirm wheel runout and clearance before use. This listing is for a single axle part and not a full assembly.

Will this axle fit a variety of chassis?

The axle is compatible with hubs that accept a BB DJC style shaft. Confirm your hub bore and bearing arrangement before purchase to ensure Arrowmax AM-010083 fits your chassis.

How should I service the axle after use?

Clean mating surfaces and 走珠軸承 after runs, check for surface nicks or bends, and replace the axle if you detect deformation or significant wear to maintain accurate wheel alignment.

Can I use this axle to correct wheel runout?

A true-to-spec axle like Arrowmax AM-010083 provides a stable mounting surface which helps when adjusting wheel offset and reducing runout, but final results depend on the full hub and bearing setup.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved