Aftermarket Rear Crank & Ball Rod Set for TAMIYA Hotshot - JR-THS09-GU by Jazrider  [JR-THS09-GU]

Tamiya Hotshot Rear Suspension Crank (Parts E2, E4, E6) With Ball Rod Set (Gun Metal)
Price:
£4.83
Brand:
JAZRIDER
Model:
JR-THS09-GU
Condition:
Brand New
Available in shop
Write a review

Replacement rear suspension crank and ball rods for Hotshot

This replacement set is specified for the Tamiya Hotshot rear linkage and corresponds to the original E2, E4 and E6 parts. The package includes the rear crank elements plus a matched ball rod set finished in gun metal, intended for spare use or during maintenance and setup.

Presented as direct-fit parts, the components are suitable for renewing worn linkage hardware or rebuilding the rear end. The recommended procedure removes the original E2/E4/E6 components and fits the supplied crank and ball rods, confirming smooth joint function and correct alignment before normal operation.

These are service pieces intended to restore correct geometry and reduce linkage wear; they do not add electronic or structural changes to the chassis. Inspect mating hardware and bearings during assembly and make sure the ball rod joints operate freely.

Which factory parts do these replace on the Hotshot?

They replace the rear suspension linkage components designated E2, E4 and E6 on the Hotshot, providing direct substitution for those items.

Is the finish corrosion resistant?

The parts are supplied with a gun metal finish intended for appearance and basic protection; treat them as service replacements and inspect for corrosion in harsh conditions as part of routine maintenance.

Any advice when fitting to an older model Hotshot?

Check the condition of mating pins, ball joints and bearings before fitting. Replace any worn items, then install the new crank and ball rods, ensuring correct alignment and free articulation before tightening fasteners.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved