Aftermarket TRX4M Brass Front Steering Blocks TRX4M021X by GPM  [TRX4M021X]

Aftermarket brass blocks for TRX4M steering

These CNC machined brass front steering blocks are made for TRAXXAS TRX4M 1/18 scale crawlers and are sold under model TRX4M021X. The parts are intended solely for RC scale applications and act as weighted steering components to modify front-end mass and steering response.

They are intended for front steering block replacement to fine tune nose weight and low-speed traction while crawling. The kit replaces the factory plastic steering blocks and supplies the bearings shown, allowing reuse of existing linkages where suitable. Typical fitting requires wheel removal and access to the front knuckle; always check fastener lengths and steering geometry after installation to ensure correct handling.

Fit these brass blocks to add front-end ballast and firm up the steering anchor on 1/18 TRX4M crawlers, then verify and adjust steering geometry as required.