Aluminium Front Shock Holder for X4F (fixed, +1mm) XRAY 301977  [XR-301977]

XRAY 301977 - X4F Aluminium Shock Holder Front Fixed +1mm - Swiss 7075 T6 (2)
Price:
£38.25
Brand:
XRAY
Model:
XR-301977
Condition:
Brand New
Write a review

X4F front fixed shock holder - product details

The XRAY 301977 front shock holder is an aluminium upgrade that shifts the shock mounting position on the X4F front end by +1mm to increase suspension travel and permit revised shock angles.

It offers three flex-adjustable mount positions and the option to use thin shims for finer angle adjustments, so you can tune front compliance and transient response while keeping base geometry intact.

Finished from Swiss 7075 T6 aluminium, the two-piece set is intended for repeated setup work and competitive use. The pack contains 2 pcs to outfit both front shock mounts on compatible X4F front assemblies.

Specifications

  • Item: X4F front aluminium shock holder
  • Material: Swiss 7075 T6 aluminium
  • Model Number: 301977
  • Compatibility: X4F front end
  • Quantity: 2 pcs
  • Adjustable positions: 3 flex positions, shim-adjustable for finer angle increments

Where it fits

Fits X4F front end configurations that use a replaceable fixed front shock mount. Suitable for touring and competition-style cars that accept X4F front assemblies.

Use this holder to make small, repeatable adjustments to front shock angle and to gain a small increase in travel while keeping changes reversible at the shock mount.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this work on all X4F variants?

It is designed for X4F front end layouts that list the fixed front shock holder as a replaceable part. Verify your front assembly matches the X4F fixed mount design before ordering.

Do I need to alter roll centre after fitting?

Major roll centre changes are unlikely from a +1mm lift, but the altered shock angle can affect initial compliance; evaluate cornering balance and make small chassis or spring adjustments if necessary.

Is any special machining required to fit these holders?

No additional machining should be required. Install using the stock fasteners and locations specified for the X4F front fixed mount; confirm fit and alignment before final tightening.

Can these be used as a long-term replacement part?

Yes. Manufactured from Swiss 7075 T6 aluminium, they serve as a durable upgrade option for drivers seeking repeatable tuning and improved mount strength over stock aluminium options.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved