APC AP0806EP 8x6EP Propeller for Electric Reverse/Pusher  [AP0806EP]

APC PROPELLER 8x6EP ELECTRIC REVERSE/PUSHER
Price:
£2.83
Brand:
APC
Model:
AP0806EP
Condition:
Brand New
Write a review

Reverse and pusher propeller overview

The APC AP0806EP propeller is offered as an RC accessory for electric reverse and pusher configurations. The 8x6 designation in the model name identifies the size, and the paragraphs below explain fit checks, installation safety, and the propeller's role when refining thrust and balance.

Check that the prop hub matches your motor shaft or any required adaptor before fitting. Verify direction of rotation and tighten the mounting hardware to prevent slippage during higher RPM operation. Use a prop balancer and conduct progressive bench testing when changing propellers or pitch settings.

Use this propeller as part of the propulsion system that includes motor, ESC, and airframe geometry. Any adjustment to prop size or pitch should be recorded with RPM and current measurements to ensure the whole system stays within safe parameters.

How should I balance this propeller?

Use a hand or digital prop balancer to check for heavy spots, remove material from the heavy blade or add tape to the light blade until the prop sits level. Proper balance reduces vibration and component stress.

Will changing to this prop require ESC tuning?

Potentially. A different pitch or diameter can change load characteristics. After fitting, verify ESC telemetry and adjust throttle curves or timing only if logs show unacceptable current draw or temperatures.

When should I re-check clearances after switching props?

Always re-check clearances during initial ground runs and again after a short flight. Vibrations or minor flex can alter spacing, so inspect mounting points and surrounding structures routinely.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved