APC AP09045EP 9x4.5EP Electric Reverse/Pusher Replacement Propeller  [AP09045EP]

Overview of pusher/reverse prop use

This APC AP09045EP 9x4.5EP propeller is offered as an RC-scale replacement suited to electric pusher or reverse-thrust setups. It arrives as a single blade intended for small electric models with rear-mounted motors.

Fitment checklist: verify the prop bore matches your prop adapter or collet, balance the blade on a hobby balancer, and attach using the correct nut or collet for your motor shaft. Check that the rotation direction produces the intended thrust and run a low-throttle static test to ensure adequate clearance and acceptable vibration levels.

Care and tuning: choosing this prop will influence static thrust, cruise RPM and noise without changing the motor or ESC. Inspect frequently for chips or cracks, rebalance after repairs, and replace any prop showing structural faults to avoid extra wear on motor bearings.

• Compatibility note: Designed for electric models using pusher or reverse layouts; it does not list specific vehicle models.
• Installation tips: Always balance before first flight, tighten to the proper feel, and verify after the initial run.
• Tuning advice: Alter pitch to adjust thrust and RPM, and monitor motor temperature when testing different props.