APC AP25125E Propeller 25x12.5E for Electric RC  [AP25125E]

APC PROPELLER 25x12.5E ELECTRIC
Price:
£15.39
Brand:
APC
Model:
AP25125E
Condition:
Brand New
Write a review

RC Electric Propeller Overview

The APC AP25125E is an electric-model propeller provided as a single replacement item for fixed-wing RC aircraft. It is specified as a 25x12.5E configuration and can be selected when tuning thrust or flight behavior.

Mounting follows typical prop installation practice: confirm spinner and hub compatibility, secure the prop to the motor or adapter per their instructions, and carry out a static balance check prior to flying. Apply the correct hardware and torque values for your shaft and adapter type.

Using this prop will affect static thrust, the RPM under load, and the motor/ESC workload; always monitor temperatures during testing. Replace any prop that shows cracks, major nicks, or warping to prevent vibration and control degradation.

Specifications

  • Item: Propeller
  • Material: Not specified by manufacturer
  • Model Number: AP25125E
  • Compatibility: Electric RC aircraft and fixed-wing models

A useful spare or tuning prop for electric model pilots seeking a 25x12.5E; always verify fit and run balance tests before operation.

The prop carries the model code AP25125E from APC; this corresponds to the 25x12.5E nominal size and pitch used to match it to aircraft requirements.
Measure the hub bore and compare with your spinner inner diameter or adapter specifications. If the fit is loose, use an appropriate collet or shim to obtain a secure, concentric mounting.
Ensure the hub seats flush, tighten fixings uniformly, statically balance the prop, and perform a ground run at low speed to confirm minimal vibration before flying.
Discard the prop if cracks, deep gouges, or permanent warping are present. Persistent vibration after balancing is another clear indication it should be replaced.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved