Arrowmax AM-464041 64P 41T Pinion Gear (SL) Performance Edition  [AM-464041]

Arrowmax AM-464041 Pinion Gear 64P 41T(SL)
Price:
£4.36
Brand:
Arrowmax
Model:
AM-464041
Condition:
Brand New
Write a review

Precision 64P 41T Pinion from Arrowmax

The Arrowmax AM-464041 pinion is designed to offer accurate tooth engagement for enthusiasts seeking steady drivetrain behaviour. Its 64-pitch 41-tooth profile prioritises consistent power flow from motor to driven gears.

Compatibility and Setup Advice

This unit fits a range of 64P systems and is straightforward to fit when shaft size and spacing are correct. Proper mesh adjustment is essential to get the best results and to avoid accelerated wear.

Why Experienced Builders Choose Arrowmax

Arrowmax produces components with close tolerances and attention to finish, and this pinion reflects that approach by helping reduce noise and improve overall drivetrain reliability when installed correctly.

How do I check shaft compatibility?

Measure your motor shaft diameter and confirm the grub screw position lines up; the pinion must seat fully without slop for safe operation.

Can this pinion reduce drivetrain noise?

Correctly matched 64P gears with good mesh often run quieter due to even tooth contact, but alignment and wear state are key factors.

Should I replace after a crash?

Inspect teeth for chips and check the set screw for loosening; if any damage is found, replace the pinion to avoid damaging the spur or motor.

What final drive changes with 41T?

A 41-tooth pinion affects overall gearing ratio versus other tooth counts, altering acceleration and top speed—calculate ratios before swapping to match your driving goals.

Any installation tools recommended?

A pinion holder, small hex keys and a calibrated driver help set grub screw torque and ensure the pinion sits correctly on the motor shaft.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved