Arrowmax AM-601015 Ultra Pinion 15T Module 1 Performance Pinion  [AM-601015]

Arrowmax AM-601015 Ultra Pinion 15T Modul1 (spring steel)
Price:
£6.66
Brand:
Arrowmax
Model:
AM-601015
Condition:
Brand New
Write a review

Performance Modul1 Pinion from Arrowmax AM-601015

The Arrowmax AM-601015 Ultra Pinion 15T Modul1 is produced from spring steel to deliver steady, long-lasting engagement in Modul1 gear systems. Fine tolerances promote quiet running and dependable power transfer in everyday RC use.

Wear Resistance and Consistency

Spring steel construction gives the pinion strong resistance to wear and consistent tooth form under stress. This helps keep backlash predictable and reduces the need for frequent replacements.

Suitable for Various Applications

Made for Modul1 setups, this pinion works across a range of electric RC cars where a 15T tooth count is required. It is a practical component for both club racers and hobbyists maintaining their fleets.

What checks should I perform after installation?

After fitting, rotate the drivetrain by hand to verify smooth mesh, then run short tests under light load to confirm there is no binding or unusual noise.

Is this pinion compatible with 48 pitch spurs?

Compatibility depends on the module. This pinion is for Modul1 spacing; verify the spur matches Modul1 rather than assuming 48 pitch.

Any tips for set screw security?

Clean the motor shaft flat, use a thread locker if appropriate for your setup, and check the screw tightness after the first few runs to prevent loosening.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved