Auper D6 Ball End and Turnbuckle Kit SAK-D6807D by 3Racing  [SAK-D6807D]

Linkage components for setup and maintenance

This 3Racing SAK-D6807D set supplies ball ends and steel turnbuckles intended for use on the Auper D6 RC chassis, serving as direct replacement components for steering and suspension linkage points.

The steel turnbuckles secure threaded adjustment for alignment rods while the ball ends permit smooth articulation to minimise binding during travel. These parts restore worn linkages and deliver a dependable adjustment range for tuning sessions.

To fit, remove the existing ball end or turnbuckle, seat the new ball end onto the linkage or servo horn, then rotate the turnbuckle to achieve the correct length and geometry. Verify locking method or thread engagement and recheck after a short test run.

Setup advice: adjust turnbuckles in small steps to observe handling shifts; small toe or camber changes can significantly alter grip and balance at different phases of a corner.