Auper D6 compatible ARS link mount SAK-D6808D/BU - blue aluminium by 3Racing  [SAK-D6808D/BU]

Price:
£7.43
Brand:
3Racing
Model:
SAK-D6808D/BU
Condition:
Brand New
Write a review

Overview of the aluminium ARS linkage mount

This aluminium ARS linkage mount is a direct replacement hop-up built for the Auper D6 1/10 scale RC chassis. It supplies the ARS mounting point used to change link lengths and lateral placement so you can dial steering geometry without swapping the main arms.

To fit, remove the OEM linkage mount and locate this aluminium piece in the same position on the Auper D6 chassis, then reconnect the steering linkage and confirm neutral alignment. The aluminium body provides a firmer mount than standard plastic parts and may reduce play at the linkage pivot.

Setup guidance: experiment with small tie-rod length and lateral offset adjustments to feel how steering bite and transient response evolve. Keep notes of each run so you can replicate or revert changes based on track performance.

Does this mount accept different linkage rod ends?

The mount uses the same ARS mounting positions as the stock unit on the Auper D6, so it is compatible with the rod ends and link hardware designed for that chassis. Check thread sizes and rod end types for fitment confirmation.

Will I need to alter suspension arms to use this?

No arm changes are required; the mount is intended to replace the stock linkage mounting point and preserve existing suspension arm geometry while enabling ARS tuning.

Is any special maintenance required?

Inspect mounting screws and pivot clearances after initial runs. Periodic checks for tightness and free movement will keep the mount performing as intended.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved