Auper D6 Motor Mount Upgrade Base B SAK-D6808G/BU - Blue Aluminum by 3Racing  [SAK-D6808G/BU]

Price:
£4.16
Brand:
3Racing
Model:
SAK-D6808G/BU
Condition:
Brand New
Write a review

Motor mounting solution for Auper D6 chassis

This aluminium Motor Mount Base B is a direct-replacement accessory designed for the Auper D6 RC chassis. It supplies a stable mounting face for the motor and uses the chassis' original mounting points to retain correct fitment.

Crafted from anodised blue aluminium, the component concentrates on precise motor alignment and repeatable placement rather than decorative intent. Accurate alignment supports reliable pinion-to-spur contact and can reduce premature gear deterioration on model-scale RC cars.

  • Compatibility: Intended specifically for Auper D6 chassis mounting points.
  • Installation role: Remove the OEM motor base, fit this unit, then confirm motor height and mesh before fully securing.
  • Tuning impact: Provides consistent motor positioning which aids pinion engagement setup and overall drivetrain feel.

Does this fit older D6 variants or only the current kit?

Fitment depends on the D6 variant's motor mount hole pattern; it is designed for standard Auper D6 points, so verify your chassis pattern against this design before purchase.

How should I check gear mesh after fitting?

After installing the base and clamping the motor, rotate the spur by hand and check pinion-to-spur contact across several teeth, then fine-tune height or shims as needed.

Are replacement screws available if mine are worn?

The mount uses the chassis' existing fasteners; source replacement screws of the correct thread and length if originals are damaged to ensure secure mounting.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved