Auper D6 Rear Aluminium Body Post SAK-D6820/PU Purple by 3Racing  [SAK-D6820/PU]

Rear aluminium body post

This product is an aluminium rear body post intended for the Auper D6 chassis and is listed under model SAK-D6820/PU. It acts as a direct replacement or an upgrade for the rear body mount, keeping the shell secured during handling and setup without changing the body geometry.

Fitment is restricted to Auper D6 body mounts as the name suggests, so confirm that your chassis uses the same rear post position before purchasing. The purple finish provides a visual accent while still functioning as a dependable mounting piece.

Fitting is uncomplicated: remove the existing post, place the new post into the factory hole and fasten using the original hardware or compatible body clips; common hex drivers and pliers are generally sufficient. Recheck the shell alignment after installation and trim where necessary to restore clip clearance.

For setup work the rear post gives a consistent datum for shell placement and a sturdy anchor for rear clips when checking adjustments such as ride height or roll stiffness; it supports setup consistency rather than acting as a performance tuning device.