Awesomatix A12X Suspension Plate X - Direct-Fit 3.0mm Graphite O-ACPP01 by Factory Pro  [FP-O-ACPP01]

Price:
£15.86
Brand:
Factory Pro
Model:
FP-O-ACPP01
Condition:
Brand New
Write a review

Fitment Notes for A12X Chassis

This Factory Pro aftermarket suspension plate is manufactured for the Awesomatix A12X platform and installs as a direct-fit graphite top plate for either the front or rear suspension assembly depending on your chassis layout. The 3.0mm graphite construction keeps dimensions stable and weight appropriate for 1/12 scale touring models.

Installation hinges on the A12X hole pattern and geometry, so most buyers will reuse original screws and spacers. Confirm hole alignment and surrounding clearances before final assembly to ensure the plate sits flush and does not interfere with components like servo arms or shock towers.

Changing plate thickness or material modifies local stiffness in the suspension stack and can affect transient response and roll balance without changing link geometry. This graphite plate is aimed at users wanting a controlled stiffness alteration while retaining factory mounting points.

Specifications

  • Item: Suspension Plate X
  • Material: Graphite
  • Model Number: O-ACPP01
  • Compatibility: Awesomatix A12X
  • Thickness: 3.0mm

Use this Factory Pro graphite plate when you require a stable replacement or a measured change in suspension stiffness for A12X vehicles; always check fit before track use.

Will this plate fit all A12X body and chassis variants?

It is designed around the standard A12X mounting pattern. Variants with modified hole patterns or custom chassis work may require checks or minor adjustments to ensure compatibility.

Are additional hardware kits recommended for unusual layouts?

If your chassis has nonstandard stack heights or altered mounting points, a custom screw or spacer kit may be needed. Measure and order parts accordingly.

Does the plate require any finishing before fitting?

Most plates are ready to install, but deburr any machining marks and test fit to ensure no sharp edges contact other components.

How do I verify the plate is seated correctly?

Tighten fasteners lightly, cycle the suspension and steering through full travel, then retorque. Confirm there is no rubbing or binding before completing assembly.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved