Axial 1/6 SCX6 Rear Shock Tower Replacement (Aluminum) - JR-SCX604-TI by Jazrider  [JR-SCX604-TI]

Axial 1/6 SCX6 Jeep Aluminum Rear Shock Tower Set (Titianum)
Price:
£15.46
Brand:
JAZRIDER
Model:
JR-SCX604-TI
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Overview of Rear Mount Upgrade

This is a scale RC rear shock tower upgrade designed for Axial 1/6 SCX6 Jeep models and referenced as JR-SCX604-TI. The unit replaces the stock rear shock tower to offer a more rigid mounting platform for the rear suspension, which helps maintain shock alignment and consistent behaviour on technical terrain.

The component is advertised as an aluminum rear shock tower set with the description "Titianum". It is sold as an RC-scale replacement tailored to the SCX6 rear suspension geometry and is not suitable for full-size vehicles.

Installation advice: the part is built to be a direct replacement for the factory rear tower. Installation normally requires common hand tools to remove the original and fit the new tower; confirm screw lengths and engagement prior to final torqueing. Install using the SCX6 chassis mounting points specified for the model.

Specifications

  • Item: Axial 1/6 SCX6 Jeep Aluminum Rear Shock Tower Set (Titianum)
  • Material: Aluminum, Titianum
  • Model Number: JR-SCX604-TI
  • Compatibility: Axial 1/6 SCX6 Jeep JLU Wrangler 4WD

This aluminum rear shock tower set is suitable when you want a firm rear shock mounting solution for scale trail use on Axial SCX6 vehicles; always verify fit and fastener suitability before completing installation.

Is the tower compatible across SCX6 variants?

The listing specifies compatibility with the Axial 1/6 SCX6 Jeep JLU Wrangler 4WD. Confirm your variant and mounting point layout before purchasing.

Do I need to change shock settings after fitting?

Because the mount is stiffer, reviewing spring rates and damping is recommended to fine tune handling and maintain desired articulation.

What should I check during trial fit?

Check clearance, correct alignment of shock eyes, and that screws fully engage without bottoming out or causing binding.

Are special fasteners required?

Often stock fasteners will fit, but confirm length and thread type. Replace with appropriate screws if factory hardware is unsuitable.

How does this affect long term maintenance?

Periodic checks of screw torque and inspection for impact damage will help ensure the aluminum tower remains secure and performs as expected over time.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved