Axial AX10 Deadbolt Compatible Front Offset Link Mount - AX10-24013-OR by Jazrider  [AX10-24013-OR]

Axial Racing AX10 Deadbolt Aluminum Front Offset Axle Link Mount
Price:
£8.59
Brand:
JAZRIDER
Model:
AX10-24013-OR
Condition:
Brand New
Write a review

Front Link Mount Details

This scale front offset axle link mount fits the Axial AX10 Deadbolt platform, model AX10-24013-OR. The part repositions the front link connection outward from the axle centreline to adjust steering and suspension response while remaining straightforward to install on typical AX10 Deadbolt setups.

Fabricated from aluminium, the mount increases rigidity at the link pickup area compared with many factory plastic mounts, helping to maintain link geometry under load and during precise low speed crawling. It is supplied as an upgrade intended for RC rock crawling and off road tuning where consistent axle behaviour is valued.

Installation notes: the mount replaces the stock front link mount and uses the existing fastener points on the AX10 Deadbolt axle housing. Once fitted, check link angles and wheel clearance through full suspension travel and alter link lengths or pivot spacing as necessary to obtain the desired roll centre and steering feel. Revisit fastener torque after initial runs.

Can this be used with modified axle housings or aftermarket parts?

The mount is designed for standard AX10 Deadbolt front axle housings. If you are using non standard or heavily modified housings, verify alignment and mounting dimensions before final fitment.

What torque should be used on the fasteners?

Use a moderate torque setting to secure the mount, avoid over tightening, and recheck all fasteners after the first runs to ensure nothing has loosened.

Will this move the roll centre significantly?

The offset will influence roll centre; the exact effect depends on your link geometry and pivot spacing. Test and tune link lengths to reach the handling balance you want.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved