3RACING AX10-16 Scorpion Brushless Motor Adapter Plate 28mm  [AX10-16]

AXIAL AX10 Scorpion Chassis 28mm Brushless Motor Plate - 3RACING AX10-16
Price:
£3.75
Brand:
3Racing
Model:
AX10-16
Condition:
Brand New
Write a review

3RACING AX10-16 Motor Plate Summary

The 3RACING AX10-16 brushless motor plate is built to give the AXIAL AX10 Scorpion chassis a tidy mounting point for 28mm brushless motors. Installation is direct and the plate secures the motor in a consistent position for reduced drivetrain stress.

Compatibility and Practical Uses

This plate is aimed at hobbyists and club racers who run 28mm brushless motors. It accepts a wide range of 28mm cans, making it useful for swapping motors as you tune for torque or speed without changing the chassis mounting layout.

Installation Recommendations

Ensure all motor mount screws are seated correctly and check alignment after first use. Small shims can correct minor mesh issues, and routine checks will keep the motor secure during rough use.

Will this plate fit my 28mm motor without drilling?

Most 28mm motors should fit without extra drilling, but confirm the motor's mounting hole pattern against the plate before final installation.

Can this plate improve drivetrain longevity?

By keeping the motor aligned and reducing unwanted movement, the plate can help reduce wear on gears and shafts when fitted and maintained correctly.

Any tips for motor ventilation?

Allow clearance around the motor can and ensure airflow where possible, especially if running higher power setups that produce heat.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved