AXIAL CAPRA 1.9 Front/rear brass gearbox cover upgrade CP012AX by GPM  [CP012AX]

Brass gearbox face plates for CAPRA 1.9 UNLIMITED

This 5-piece brass front and rear gearbox cover set is intended for the AXIAL CAPRA 1.9 UNLIMITED chassis. Precision brass covers plus stainless steel cap head screws are supplied to protect gearbox housings and add rotational mass that helps steady the differentials during low-speed trail and rock crawling.

Fabricated from brass, the kit lists an assembly weight of 67 grams in the source data. That extra mass provides a tuning point for traction and balance on scale trail rigs without altering gear ratios. Compatibility is specified for AXIAL CAPRA 1.9 UNLIMITED only, so treat this as an aftermarket part when planning suspension or driveline setup adjustments.

Installation requires removal of the original gearbox cover and attention to sealing elements for reuse or replacement. Use the supplied 2.5x16 stainless cap head screws and tighten to standard small-scale RC torque levels to prevent strip or misalignment, then rotate the differential by hand to ensure correct mesh and bearing seating.

Opt for this brass cover set when you want increased gearbox protection plus a calibrated weight shift for better low-speed diff behaviour on an AXIAL CAPRA 1.9 UNLIMITED; recheck screw torque and gear mesh after fitting and run a brief test to confirm handling.