AXIAL Racing RR10 Bomber Main Drive Shafts Adjustable Front & Rear 6061 T Aluminium with Steel Retention - RR237SA by GPM  [RR237SA]

Adjustable 6061 T aluminium shafts with steel retention

This adjustable set is intended for use with the AXIAL Racing RR10 Bomber and is listed under model RR237SA. The parts combine steel retention hardware and a 6061 T aluminium shaft body to provide strength where needed while minimising rotating mass.

Fastener security is improved using a steel wire ring that helps prevent screws backing out under vibration. The front shaft is adjustable between 147mm-157mm and the rear between 122mm-130mm, matching typical front and rear length requirements during setup.

Designed for replacement or upgrade, these shafts can help you fine-tune driveline geometry after altering ride height or suspension travel. Always inspect joint fit and runout after fitting and apply thread-lock as recommended by your chassis instructions.

If you want adjustable, lightweight replacement shafts for the RR10 Bomber, the RR237SA set supplies the needed lengths and secure retention hardware to maintain consistent drivetrain operation.