Axial Racing SCX-10 Compatible Rear Axle Service Part ASCX10-22115X by Jazrider  [ASCX10-22115X]

This RC rear axle assembly is intended for Axial SCX-10 chassis applications and comes as a pre-assembled aluminum rear axle unit. It is offered as a replacement or service part for scale rock crawlers, emphasising correct fit and straightforward servicing rather than performance claims.

Installation guidance: the assembly ships pre-built to reduce assembly steps during installation. When fitting to an SCX-10 chassis, confirm the axle orientation and tighten mounting hardware to the torque values referenced in your SCX-10 documentation. Apply appropriate thread-lock and check driveshaft coupling areas for wear prior to completing the assembly.

Service notes: this axle functions as a drop-in replacement to restore chassis geometry or to replace a worn rear end. For setup checks, verify axle alignment under load, confirm pinion engagement, and re-check wheel hex retention after initial runs. Routine inspection of bearings and fasteners will help sustain predictable handling on scale trails.