AXIAL Racing SMT10 Aftermarket Aluminium Wheel Hex +2mm - MJ0102/+2MM by GPM  [MJ0102/+2MM]

Aftermarket wheel hex for SMT10

This aluminium wheel hex is made for AXIAL Racing SMT10 and is supplied as a 2pcs set with a +2mm offset to alter track width while keeping wheel backspacing unchanged. It is intended for hobby model use and for tuning wheel position and handling on SMT10 chassis.

Function and benefit: the hex adjusts wheel mounting stance to allow small changes to track width for setup or clearance. Machined aluminium construction improves wheel retention over plastic hexes and helps preserve wheel alignment under the loads encountered in model running.

Fitting guidance: replace the original wheel hex with these aluminium units using the existing axle and wheel hardware on SMT10 layouts. After installing a +2mm offset, check tyre and suspension clearance, hand-tighten components then apply your regular wheel torque. Not for real vehicle use.

Included hardware: the package supplies the wheel hexes plus the small fitting parts commonly needed during installation, listed here for clarity: 2pcs wheel hex, 2x10.9 steel pin - 2pcs, 2x7 steel pin - 2pcs, 2.5x2.5 screw shaft - 4pcs, 1.2 hex socket key - 1pc.