Axial Racing Yeti Rear Axle Support Bracket YT168R by GPM  [YT168R]

Axle protection and chassis support

This aluminium and plastic rear axle protector mount is an RC-scale replacement built for the Axial Racing Yeti platform. It serves as a protective support for the rear axle, reducing direct impact stresses while preserving suspension geometry during demanding off-road use.

The assembly uses machined aluminium where structural support is required and plastic interface parts to allow damping and accurate fitment. Fitting is carried out with standard RC hardware and common workshop tools; the part is supplied as a single set and replaces the original rear axle protector mount to give a stiffer load route from chassis to axle.

In setup terms the YT168R helps defend the rear axle and modifies axial compliance between chassis and axle slightly. Model builders choose this part when they need consistent axle alignment after impacts or when fitting alternate driveline elements that require a stronger mounting point.

A sensible aftermarket upgrade for scale RC drivers looking for a mix of rigidity and tolerance at the rear axle; always verify part fit and hardware before finishing the install.