Axial RR10 Bevel Gear Pair RR1200S Steel Upgrade for Bomber Yeti Wraith by GPM  [RR1200S]

Axial Racing RR10 Bomber Steel Front/Rear Bevel Gear - 2pcs (For RR10 Bomber / Yeti / Wraith) (AX30392)- 2pcs - GPM RR1200S
Price:
£17.77
Brand:
GPM
Model:
RR1200S
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Steel bevel gear replacement for RR10 models

The RR1200S item is a two-piece steel bevel gear set intended for the front and rear axle applications on the Axial platforms listed below. The steel construction is provided as a more wear-resistant alternative to common stock bevel materials used in scale applications.

This set is appropriate when replacing worn bevels or when upgrading a drivetrain for heavier loads during crawling or trail running. The gears transmit torque between driving and driven shafts at right angles inside the axle or gearbox on RR10 Bomber, Yeti, and Wraith chassis.

Installation advice: remove the axle or gearbox cover to access the bevels, inspect mating gears and bearings for wear, ensure correct tooth mesh and axial alignment, and apply appropriate lubricant before running. Verify smooth rotation under no-load conditions prior to full-power use.

Compatible Models

  • RR10 Bomber
  • Yeti
  • Wraith

A simple steel replacement pair for Axial RR10 drivetrains where enhanced durability and wear resistance are desired, supplied as two pcs for front and rear installation.

Do these bevels require shim adjustment?

Adjust tooth mesh and check axial play during fitment; minor shimming may be needed on some setups to achieve the correct engagement.

How should I check for proper mesh after fitting?

Rotate the axle by hand and watch for smooth contact across the tooth faces, then run a low-speed power check while listening for binding or grinding.

Are these suitable for rock crawling events?

Steel bevels offer better wear resistance than many stock materials, making them a sensible choice for demanding crawling, though check the whole drivetrain for other weak points.

What should I inspect before fitting these gears?

Inspect bearings, pinions and gear faces for wear or damage and replace any suspect parts to ensure reliable mesh and long service life for the new steel bevels.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved