This aftermarket aluminium hex claw set is supplied as two pieces and is produced for Axial SCX-10 II wheel hubs. Each item is an aluminium front/rear hex claw featuring a brake-disk outline and a 3mm extension to the hex so the wheel offset is moved outward.
The claw geometry helps the wheel engage the hub under slip by providing a mechanical claw surface that holds the wheel and tyre more effectively during low traction sections. The 3mm widening adjusts the track width and can improve vehicle composure on uneven ground.
The engraved brake disk is an outline cut that lowers the mass of the disk area slightly while keeping the part material as aluminium. This component is sold as an aftermarket upgrade for scale trail and rock-crawling setups rather than as an original part.
Fit this set if you want a small track increase and a claw-type hex interface on SCX-10 II Jeep Cherokee AX90046 machines, and verify hub fitment and fastener length before final installation.
Copyright © 2008-2026 rcjaz.co.uk All rights reserved
