AXIAL SCX10 III Rear Bumper Mount 6061 T6 Scale Upgrade SCX3331R by GPM  [SCX3331R]

Scale aluminium rear bumper mount for SCX10 III

This aluminium rear bumper mount is produced for the AXIAL SCX10 III JEEP WRANGLER and carries model SCX3331R. The component pairs a machined 6061 T6 aluminium structure with the required mounting hardware to secure the rear bumper and improve the durability of the chassis mounting points on scale RC models.

The mount uses a hollowed 3D-cut profile to lower weight while maintaining stiffness where fasteners anchor the bumper. It is intended to stabilise load transfer to the rear during trail driving and light impacts, rather than to function as full-size hardware. The supplied screws enable a direct replacement or upgrade from the stock plastic bracket.

When fitting, inspect clearance around the rear body mounts and any existing bumper supports on your SCX10 III Wrangler replica. Because the aluminium part modifies how loads move into the rear section, re-torque fittings after a few runs and confirm the bumper aligns correctly with the chassis rails.

This aluminium rear bumper mount is a practical upgrade for the AXIAL SCX10 III Wrangler, improving mounting rigidity and offering more robust hardware for regular scale trail use.