AXIAL SCX30 Center Gear Box Mount Skid Plate - 18g SCX30/38X by GPM  [SCX30/38X]

Scale brass center gear box mount for SCX30

This replacement centre gear box mount skid plate is precision machined from solid brass for AXIAL SCX30 platform vehicles. The single 18g brass unit is intended to replace the factory part number AXI-3311 and mount at the chassis centre where the gearbox is attached. It is intended for 1/30 scale RC crawlers rather than full-size use.

The part adds concentrated mass at the chassis centreline, helping to balance front and rear traction and improving low-speed climb stability on technical sections. The hardware included covers common thread sizes used on SCX30 assemblies and enables a direct swap with the original mounting locations.

Fitting advice: remove the stock centre mount, position the brass plate on the existing screw bosses, and use the supplied round head screws to secure. Use the correct hex driver and hand-tighten first, then snug to final torque to prevent stripping. Confirm suspension and driveline clearance prior to full operation.

For AXIAL SCX30 1/30 crawlers this brass centre mount is a straightforward aftermarket upgrade to shift weight and aid low-speed traction; always verify fit and torque settings during installation.